Post Trip Equipment Maintenance and Storage

Main Page

Vehicle Information - Technologies - Fuels and Fuel storage - Information tables and Reference - Techniques - Water and Food - Stuff to do - Tracks to Follow - Preps when traveling - Overland Essentials

---

Note: This page is currently a stub with little or no information in it. If you would like to contribute to the site by writing interesting content (with full attribution and links to your site of course) please contact us on contributions@adventurestuff.wiki. Unfortunately because this is a hobby site we don't have the resources to pay for content, but we would be glad to promote you and your content to our audience.

Post-Trip Gear Maintenance & Storage

The "End of Trip" doesn't happen when you pull into your driveway; it happens when every piece of gear has been cleaned, inspected, and stored correctly. Neglecting this leads to seized winches, rotted tents, and brittle recovery ropes.

1. Recovery Gear: Ropes and Winches

Recovery equipment is often exposed to the most abrasive elements (sand, mud, salt water).

• Synthetic Ropes & Snatch Straps: Mud and sand grains act like tiny saws, cutting the internal fibers of the rope under tension.
  • Maintenance: Unspool the winch rope and soak all straps in a bucket of lukewarm water with a mild, pH-neutral soap. Rinse until the water runs clear.
  • Drying:' Never dry synthetic ropes in direct sunlight (UV degradation) or under high heat. Hang them in a shaded, well-ventilated area until bone-dry before re-spooling.
• The Winch Motor: If you performed water crossings, moisture can be trapped in the motor housing.
  • Maintenance: Run the winch (power in and out) for a few minutes to generate internal heat and evaporate moisture. Apply a marine-grade anti-corrosion spray to the electrical terminals.

2. Camping Gear: Tents and Awnings

The primary enemy of canvas and technical fabrics is mold and mildew.

• The "Deep Dry": Even if it didn't rain, morning dew trapped in a folded roof-top tent or awning will cause mold within 48 hours. Open all tents and awnings fully.
• Zippers: Dust and salt "lock" zippers. Scrub them with a soft toothbrush and apply a specialized zipper lubricant or a small amount of beeswax. Avoid oil-based lubricants as they attract more dust.
• Stove Maintenance: For multi-fuel stoves, empty the fuel bottles. If you used kerosene or diesel, the jets likely have carbon buildup; soak the burner head in white gas or carburetor cleaner and use a "jet prick" to clear the nozzle.

3. Electrical Systems and Fridges

• The Fridge: Never store a portable fridge closed. Even microscopic food particles will create a bacterial "science project" in the seals.
  • Maintenance:' Wipe the interior with a 10% vinegar/water solution. Prop the lid open slightly during storage to allow airflow.
• Auxiliary Batteries: If your vehicle sits for weeks after a trip, your secondary battery may drop below its "healthy" voltage (12.4V for Lead Acid/AGM).
  • Maintenance:' Connect a "smart charger" or maintainer to keep the batteries topped up, preventing sulfation.

4. Water Systems

Stagnant water in tanks or jerry cans quickly develops biofilm and algae.

• Sanitization: Flush the entire system with a food-grade tank cleaner or a very weak bleach solution (approx. 50ml per 100L).
• Drainage: Open all taps and the lowest drain point. Leave caps off for 24 hours to ensure the tank dries completely to prevent funky smells on the next outing.

5. Tools and Hardware

• The Tool Roll: Inspect every tool. If they were used in the rain or mud, they will have "flash rust."
  • Maintenance:' Wipe them down with a rag soaked in Lanox or a similar lanolin-based protectant.
• High-Lift Jacks: These are notorious for seizing. Pressure-wash out the grit from the climbing pins and lubricate with a dry PTFE spray. Avoid grease, which turns into a grinding paste in the desert.

6. Long-Term Vehicle Storage (Expedition Storage)

Many overlanders "section-travel," leaving their vehicles in foreign countries or storage hubs for months between trip legs. Leaving a vehicle sitting is often harder on the mechanicals than driving it; seals dry out, fuel degrades, and rodents find new homes.

• Fuel Stabilization: Modern diesel and petrol degrade over time. If the vehicle will sit for more than three months, fill the tank to the brim (to prevent condensation and rust) and add a high-quality fuel stabilizer. For diesel engines in cold climates, ensure you have "winter-grade" fuel to prevent waxing.
• Battery Management: Even with everything off, "parasitic loads" (clocks, immobilizers) will drain a battery in weeks. If you don't have a solar panel maintaining the charge, physically disconnect the negative terminals of all batteries. For Lithium (LiFePO4) batteries, aim for a 50–60% state of charge for storage; do not store them at 100%.
• Tire Flat-Spotting: Long-term pressure on one section of the tire can cause permanent deformation. Over-inflate the tires by 10–15 psi above road pressure to help maintain their shape, or, if possible, have someone move the vehicle a few inches every month.
• Fluid Preservation: Change the engine oil right before storage. Used oil contains acidic combustion byproducts that can etch bearing surfaces if left to sit. Ensure the coolant mix is correct for the lowest possible temperature the region might experience to avoid a cracked engine block from freezing.
• The "Rodent Defense": In many parts of the world, mice and rats love the taste of modern soy-based wiring insulation. Place peppermint oil-soaked rags in the engine bay or use electronic ultrasonic deterrents. Seal the exhaust pipe and air intake with steel wool or heavy tape (just remember to remove them before starting!).

Storage Checklist

System	Action	Reason
Fuel	Fill to 100% + Stabilizer	Prevents tank condensation/algae
Batteries	Disconnect Negative Terminal	Prevents parasitic drain
Tires	+15 psi Over-inflation	Prevents permanent flat-spots
Intake/Exhaust	Seal with Steel Wool	Keeps rodents out of the engine
Handbrake	Leave OFF (Use Chocks)	Prevents brake pads seizing to rotors

Gear Retirement Criteria

Item	Sign of Failure	Action
Snatch Strap	Any cut deeper than 10% of width	Retire Immediately
Soft Shackle	Fraying or "melting" spots	Retire Immediately
Winch Cable	Flat spots or "kinks"	Retire/Replace
Gas Hoses	Surface cracking when bent	Replace
First Aid	Expired sterile seals	Replace Contents